Manifold Termojet in thermal insulation 6+1 up+down MHS62UD125(200)

Manifold with hydraulic separator KGS62VN.125(200) — the most capacious Termojet "2 in 1" unit: 6+1 circuits with upward and downward outlets and a built-in hydraulic separator GS-26 in a single housing. It simultaneously hydraulically separates the boiler circuit and distributes the heat transfer fluid to six main consumers — complete piping for a branched boiler room in one compact unit.

Operating principle: the hydraulic separator creates a low pressure-loss zone between the boiler circuit and the consumer circuits — each pump receives its calculated flow rate without mutual interference. The manifold section distributes the flow to circuits with a centre-to-centre spacing of 125 mm, with outlets directed in two tiers — upward and downward, allowing a large number of pump groups to be arranged compactly. The built-in air separator directs gases to the air vent (BSP ½″), and the dirt trap collects sediment, which is drained via a BSP ½″ valve. Mounting brackets are included in the delivery set.

Application scenarios: a large house or small commercial facility with six to seven consumers — underfloor heating, several radiator branches, DHW boiler, ventilation, swimming pool. Full hydraulic separation makes the unit ready-made piping for a heat pump with multiple circuits as well — see Termojet heat pumps. For more compact systems, consider KGS22VN.125 for 2+1 circuits up + down or KGS22N.125 with downward outlets.

Advantages of the Termojet KGS:

• 6+1 outlets in two tiers — maximum circuits on minimum wall space;
• one unit instead of a separate hydraulic separator and manifold — faster installation and fewer connections;
• air and dirt separation — less noise, corrosion, and pump wear;
• thermal insulation and mounting brackets included, Ukrainian manufacture, manufacturer's warranty.

Technical specifications: number of outlets — 6+1 (up + down), maximum capacity 60 kW at ΔT=10 °C and 95 kW at ΔT=20 °C, maximum flow rate Gmax 6.35 m³/h, boiler connection — 1¼″, heating circuit connection — 1″, centre-to-centre spacing — 125 mm.

Other "2 in 1" configurations — in the catalogue of Termojet manifolds with hydraulic separator.

Frequently Asked Questions

How many consumers can be connected to the KGS62VN?
Six main circuits with a 125 mm centre-to-centre spacing plus one additional outlet — with a total system capacity of up to 60 kW at ΔT=10 °C.

Why are the outlets directed both upward and downward?
The two-tier arrangement allows six pump groups to be arranged compactly: some circuits go up, some go down — fewer pipe runs and elbows in a tight boiler room.