Manifold Termojet in thermal insulation 3+1 up MHS32U125(200)

Manifold with hydraulic separator KGS32V.125(200) — a Termojet unit in the «2-in-1» format with three outlets upward: built-in hydraulic separator GS-26 and a distribution manifold for 3+1 circuits in one housing. A single compact unit simultaneously hydraulically separates the boiler circuit from the consumers and distributes the heat transfer fluid to three circuits — up to 60 kW at ΔT=10 °C and up to 95 kW at ΔT=20 °C.

Operating principle: the built-in hydraulic separator between the boiler pump and the consumer circuits creates a low-pressure-loss zone that eliminates mutual interference between pumps. The manifold section distributes the heat transfer fluid to three main circuits with a centre-to-centre spacing of 125 mm and an additional outlet FM ½″. The built-in air separator vents gases to the air vent (FM ½″), and the sludge trap collects dirt with drainage via a valve FM ½″. Circuit outlets are directed upward — convenient for boiler rooms with top-mounted distribution.

Areas of application: three-circuit boiler rooms — underfloor heating, radiators and DHW boiler; systems with solid-fuel boilers; installations with a heat pump where simultaneous hydraulic separation and distribution to several low-temperature circuits are required — see Termojet heat pumps. Termojet pump groups are mounted on the outlets; if only a hydraulic separator without a manifold is needed, consider the hydraulic separator GS-26 1¼″ separately.

Advantages of KGS from Termojet:

• hydraulic separation + distribution + air and sludge separation in a single unit;
• fewer fittings and pipe connections compared to a separate hydraulic separator and manifold;
• thermal insulation and brackets included — ready for wall mounting;
• Ukrainian manufacture, competitive price and manufacturer's warranty.

Technical specifications: number of outlets — 3+1 (upward), maximum capacity 60 kW at ΔT=10 °C and 95 kW at ΔT=20 °C, maximum flow rate Gmax 6.35 m³/h, boiler connection — 1¼″, circuit connections — 1″, centre-to-centre spacing — 125 mm.

Versions with outlets downward, up+down and for 2 or 4 circuits — in the Termojet manifold with hydraulic separator catalogue.

Frequently Asked Questions

When to choose a KGS and when to choose a separate hydraulic separator and manifold?
KGS is a compact solution for typical configurations up to 95 kW. Separate units offer more flexibility for non-standard layouts or higher boiler capacities.

Does the KGS purify the heat transfer fluid of air and sludge?
Yes. The built-in air separator and sludge trap perform these functions automatically — without additional separators in the system.